|
Key features :
• Lightweight at only 9 grams with
JR cable
• Small size: 37 mm x 19 mm x 7 mm
• Onboard LED to flash out max. altitude achieved in flight,
and battery voltage
• Records altitude data for later review
• FXJ switch function integrated
• PC interface for configuration, firmware updates and data
download / review
• Export data in *.txt format or as JPG image
• Accepts wide range of input power: 4–20V (DC). Power it from
aircraft receiver
• Every unit is tested in pressure chamber up to 950m for its
accuracy
• Later upgrade to PRO version is possible
• Supports RC GPS module and record GPS data
|
|
*
RC alti 02 BASIC module uses a high-resolution barometric pressure
sensor system to detect small changes in air pressure that occur
due to changes in altitude. It is sensitive enough to detect
altitude changes of less than one meter. Because it is so sensitive,
it is also sensitive to changes in weather and local pressure
variations. The designed use of this device is for measuring
short-term altitude changes in R/C aircraft. Long-term altitude
readings will vary considerable due the varying atmospheric
conditions. It is best used to measure relative changes in altitude.
* Figure shows the RC alti 02 BASIC hardware module. The module
includes an onboard LED for flashing out maximum altitude and
battery voltage.
A pushbutton is used to select one of three options (maximum
altitude, battery voltage and creating new flight while setting
altitude to zero). The JR cable is used to connect to a radio-controlled
aircraft’s onboard receiver, which powers the RC alti 02 BASIC
module. The 3-pin connector serves as servo pass-through or
as output for FXJ switch function. A modular connector is used
to interface to a PC for configuration and to download altitude
data.
* To power the RC alti 02 BASIC
module, plug the 3-pin connector on JR cable into a spare receiver
channel on the R/C aircraft. If you do not have an open receiver
channel, you can plug the RC alti 02 BASIC into the receiver,
and the plug that channel’s servo into the RC alti 02 BASIC
servo pass-through connector. Be sure to observe proper polarity
when plugging the connector into the receiver. For non-R/C use
attach a battery to the servo pass-through connector. A JST
style connector can plug directly into the 3-pin pass-through
connector. Again, be sure to observe proper polarity, or damage
may result. The 3-pin pass-through connector is oriented with
the same polarity as the adjacent servo wires.
This RC-alti 02-basic complete costs 75 EUR.
Delivery time is no more as 7 working days.
* E-mail address
for sending your order or for info about selling term details
* Link for complete RC alti 02 BASIC manual |
